Indicator Status Description:
When Charging:
Red Light Strobe: Charging
Greenlight On: Full Charged
Notice: It Is Recommended To Cool The Machine In A Cooling State Before Charging For A Better Charging Effect.
When Using:
To Activate The Staple Gun After Charging:
1st, Restart ON/OFF Switch; 2nd, Push The Trigger; 3rd, Imitate The Action Of Nailing; Then The Indicator Light Will Turn Green And Ready For Use.
The Greenlight Flash Every 4 Seconds (In Standby Mode ), To Activate The Staple Gun:
1st, Restart ON/OFF Switch; 2nd, Push The Trigger; 3rd, Imitate The Action Of Nailing; Then The Indicator Light Will Turn Green And Ready For Use.
Red And Green Lights Flash Alternately - Fault Alarm (low Power Or Jammed By A Staple):
How To Fix It: 1st, Restart The ON/OFF Switch; 2th, Remove The Staples And Reload; 3rd, If Step 1 And 2 Doesn't Work, It Means The Staple Gun Is Low Power. Please Fully Charge And Try Again.
Yellow Light On - High Battery Temperature:
How To Fix It: Stop Working And Let The Staple Gun Cool Down Until The Yellow Light Turns To Green
ATTENTION: To Switch The Staple Gun ON By Pressing The Button "-" Down, To Switch The Staple Gun OFF By Pressing The Button "O" Down.
The MAxIMUM Wood Density Is 37.45 Lb/ft3. It's Highly Recommended To Fully Recharge The Staple Gun After Use And Recharge Once Time Per 2-3months Will Prolong The Life Of The Staple Gun If The Staple Gun Is Not Used Often.
Sizes & Models Of Applicable Staples/Nails
